Disclaimer: This information is provided as is. There may be errors in this information. You may use this information only if you agree that Minimalist / Coinop.org, its employees, and noted authors will never be held responsible for any damage, injury, death, mayhem, etc. caused by errors in the information. When working with high voltage, never work alone and always follow safety precautions.

Document Title: [MakeTrax.txt (text file)]

Pinouts for MAKE TRAX (Williams, 1981)

Submitted by shu@cco.caltech.edu / essayes@telerama.LM.com

Here are the Make Trax pinouts, as promised.

Unfortunately I can't confirm it's 100% correct, as my board has a bad 
RAM so I couldn't test any of the switches.  At the very least the video
and power contacts are correctly identified.

Like I mentioned, the board is not the big multi-unit Williams setup used 
in Stargate, Robotron, etc.  It's a single board, kinda small.

36-pin edge connector

A	GND		1	GND
B	GND		2	GND
C	GND		3	GND
D	AUDIO OUT	4	AUDIO RET
E	+12 VDC		5	+12 VDC
F	COMP SYNC	6	
H			7
J			8
K	+5 VDC		9	+5 VDC
L	2P DOWN		10
M	2P UP		11	1P UP
N	2P START	12	1P DOWN
P	1P START	13	COIN
R	1P RIGHT	14
S	1P LEFT		15	RED
T	BLUE		16	2P RIGHT
U	GREEN		17	2P LEFT
V			18

}