Disclaimer: This information is provided as is. There may be errors in this information. You may use this information only if you agree that Minimalist / Coinop.org, its employees, and noted authors will never be held responsible for any damage, injury, death, mayhem, etc. caused by errors in the information. When working with high voltage, never work alone and always follow safety precautions.

Document Title: [OmegaRace.txt (text file)]

Omega Race Pinouts

Omega Race is a 2 part boardset that consist of a MOTHER BOARD PC =
(A084-90007-E929) and a LOGIC BOARD PC (A084-91372-D929) that plugs into =
the card connector on the Mother Board.

MOTHER BOARD PINOUTS

J5 6 Position

 1- GND
 2- GND
 3- KEY
 4- 8 Volt Unregulated (this is used for the BATT Charger circuit)
 5- +5VDC
 6- +5VDC

J6 3 Position

 1- 18V AC (low)
 2- 18V AC Centertap
 3- 18V AC (high)

J7 18 Position  THIS IS THE CARD EDGE CONNECTOR

 1-=20
<no connects 1-7>
 7- KEY
 8- Y OUT
 9- X OUT
10- (To Logic Board J1 Pin 19 ~ Ground for Cocktail?)
11- Z OUT
12-
13-
14-
15- Z GND
16- X GND
17- Y GND
18-

LOGIC BOARD

J1 22 Position

 1- Coin 2 Normally Closed
 2- Player 1 Thrust
 3- Tilt
 4-
 5- Player 2 Steering Encoder Bit 2
 6- Player 2 Steering Encoder Bit 0
 7-
 8- Player 2, 1 Credit light
 9- Player 2 Steering Encoder Bit 3
10- Player 1, 2 Credit light
11- Player 2 Steering Encoder Bit 4
12- Player 2 Steering Encoder Bit 5
13-=20
14-=20
15-
16- Coin 2 Meter
17- Player 2 Steering Encoder Bit 1
18- Coin 1 Meter
19- To Mother Board J7 pin 10 (Cocktail mode only?)
20- Player 2, 2 Credit Light
21- Player 1, 1 Credit light
22- +5VDC SENSE on Power Supply Board.

J2 15 Position Connector

 1- Switch GND
 2- Player 1 Steering Encoder Bit 2
 3- Player 1 Steering Encoder Bit 3
 4- Player 1 Steering Encoder Bit 5
 5- Player 1 Steering Encoder Bit 1
 6- Player 1 Steering Encoder Bit 4
 7- Player 1 Steering Encoder Bit 0
 8- Player 1 Fire
 9- Test
10- Coin 2
11- Coin 1
12- Coin 1 Normally Closed
13- KEY
14- Player 1, 1 Credit
15- Player 2, 2 Credit

J3 15 Position

 1-=20
 2- SPKR Common to both
 3- KEY
 4- SPKR 1
 5-=20
 6-=20
 7- SPKR 2
 8-
 9- +12 VDC
10- GND
11- Player 2, Fire
12- Player 2, 2 Credit
13- Player 2, 1 Credit
14- Player 2, Thrust
15-


NOTE:  The above pinouts are from my manual.  I assume no responsibility =
for any errors & would appreciate any corrections.  The single player =
versions *should* work the same way but without the 2nd Player Steering =
Encoder & Action buttons (you will need the 2 player 1 Credit/ 2 Credit =
buttons).

Kev
mowerman@erols.com
http://www.erols.com/mowerman

}