Document Title: [Spectar.txt (text file)]
Spectar Exidy, 1980
-------------------
COMP SID J1 CKT SIDE P5 P21
--------- -------- -- ---
1 A 1 GND 1 VID RED
2 B 2 +12V 2 VID GN
3 C 3 -12V 3 VID BL
4 D 4 GND 4 SYNC
5 DOWN E COIN 1 5 -5V 5 H SYNC
6 FIRE F UP 6 GND 6 V SYNC
7 RIGHT H LEFT 7 SP-A 7 GND
8 1 START J 2 START 8 +5V 8 GND
9 K 9 SP-B 9
10 GND L 10 GND 10
11 | M +12V 11 -5V
12 | N -5V 12 GND
13 | P 13 -12V
14 | R +5V 14 +12V
15 | S +5V 15 GND
16 | T +5V
17 | U +5V
18 | V +5V
19 | W
20 | X
21 GND Y
22 Z
Option Switch Settings
-----------------------------------------------------------------------------
DIP Switch Settings
1 2 3 4 5 6 7 8 Option
-----------------------------------------------------------------------------
Game Type
---------
Off Upright
On Cocktail Table
Top This Score
--------------
On Credit awarded for topping score
Off Extended play for topping score
Credits Per Coin
----------------
Off Off 1 Coin 2 Credits
Off On 1 Coin 1 Credit
On Off 2 Coins 1 Credit
For English Coins Only
----------------------
On Off Off 1 10-pence Coin 1 Credit
1 50-pence Coin 6 Credits
Off Off Off 2 10-pence Coins 1 Credit
1 50-pence Coin 3 Credits
Number of Turns
---------------
Off Off 2 Ships
On Off 3 Ships
Off On 4 Ships
On On 5 Ships
Type of Coins
-------------
Off U.S. and other
On English coins
-----------------------------------------------------------------------------
Language Selection:
To select the language, pull out the logic board. It is set low on the far
right side if you are standing behind the game cabinet.
Place the logic board with the component side up, and the biggest connnector
closest to you.
Now find location 8E, and look for two small squares, with two small circles
above them. There should be a small wire or pin between each square and circle.
Depending on the language selection you desire, you will need to make an
incision using an exacto knife at this location between the square and the
circle. You only need to make a small "V" cut into the wire.
For English, no cutting is needed
For French, cut only LNG0 (pin #8E-8)
For German, cut only LNG1 (pin #8E-7)
For Spanish, cut both LNG0 and LNG1 (pins #8E-7 and 8E-8)
}
