Disclaimer: This information is provided as is. There may be errors in this information. You may use this information only if you agree that Minimalist / Coinop.org, its employees, and noted authors will never be held responsible for any damage, injury, death, mayhem, etc. caused by errors in the information. When working with high voltage, never work alone and always follow safety precautions.

Document Title: [PacMan-badCrimp.html (html file)]

Bad Crimp Stops Pac-Man
From: Rhett James Barnes 
Organization: Time Warner Cable of San Diego, CA
Date: Thursday, January 20, 2000 12:37 AM
Subject: Tech Report:  Bad Crimp Stops Pac Man
Just wanted to pass on a report of my latest success, just incase anyone has a similar problem in the future (ok, not likely, but who knows?)

I've got a Pac Man that has been a little flakey for months. If it hadn't been on for a while, the screen wouldn't light up, and there was no H-sync noise (until the game was shut off). Though I could see glow in the neck, and the game sounds were good. If you rocked the game enough violently back-and-forth, you could usually get it to come back.

I didn't know whether it was a video prob, or if the monitor was dead (it had been recapped previously). I'm still not up to speed about plugging games into different monitors (and I thought that the Pac sync was odd). I did put check the video signals AT THE BOARD with a 'scope, and they certainly looked ok both when the game was dead and when it was working.

There's not really much on the G07 to wiggle; no daughter boards. So I wasn't sure where to go from there. Something was lose, just didn't know where. And it was causing the sync to be bad.

I was about ready to steal video from the PCB to test with a different monitor, when I decided to pull the video connectors to the monitor instead. When I pulled the sync connector off, the yellow wire from the board fell out. Turns out the crimp holding the sync wire and the jumper wire wasn't so great because it was holding two wires. It had allowed one of the wires to fall out. Re-did it, and viola.

I guess the point is, make sure that you're checking the signal from the actual connectors. I was going to steal the video at a more convenient point, which would have missed the actual problem!

Maybe it's not as universal as the "fuse" problem, but hey, might happen to someone else!

-Rhett

Clicky